No products in the cart.
SW420 NC Type Vibration Sensor Module for Arduino
Roll over image to zoom in
৳ 75.00
- Using SW-420 normally closed-type vibration sensor
- Comparator output, clean signal, good waveform, strong driving ability, >15mA
- Operating voltage 3.3V ~ 5V
- Output format: digital switching output (0 and 1)
- Using a wide voltage LM393 comparator
- With bolt holes for easy installation
- Using SW-420 normally closed type vibration sensor.
- Comparator output, clean signal, good waveform, strong driving ability, >15mA.
- Using a wide voltage LM393 comparator.
- With bolt holes for easy installation.
Note:
- Do not reverse the power directions, otherwise, it is possible to burn the chip.
- The signal LED light is output Low, signal LED OFF output is High.
- The output level is close to the input voltage.
Vendor Information
- Store Name: Labtex Bangladesh
- Vendor: Labtex Bangladesh
-
Address:
Eastern Kamlapur Complex (1st Floor), 64-68, North Kamalapur, [Opposite of Kamlapur Rail Station]
Dhaka
Dhaka
1217 - No ratings found yet!
Reviews
There are no reviews yet.